I am ordering the Wiring Harness and Small boat Switch Panel from PS- My question is... Does it come with a fuse panel, or is it all fused internally? If no external fuse panel- Does it have the ability to jump over to the gauges, or will I need to run a separate power supply for them??
Thanks again!!!
Jason
Electrical Question
Moderators: Redneck_Randy, badmoonrising, lakerunner
- curtiscapk
- Posts: 5398
- Joined: Mon Nov 10, 2008 8:31 am
- Location: OP KS\Hillsdale Lake
Re: Electrical Question
If you are talking about this one Each switch has a breaker. Technically you could use one of the power wires to the switch to power your gauges, but if you flip switch it would kill the gauges. I would t off the 12 volt outlet for your gauge power since it is always on.
http://www.pontoonstuff.com/collections ... itch-panel
http://www.pontoonstuff.com/collections ... itch-panel
Craig and Paula
"THE FLOATER" rebuild Spring 2013
viewtopic.php?f=2&t=15328
94 Party Barge 24' 115 merc
Turning Point hustler 14 x 13 prop
22mph gps 3 people
12 F150
Overland Park Ks
Hillsdale Lake, KS
"THE FLOATER" rebuild Spring 2013
viewtopic.php?f=2&t=15328
94 Party Barge 24' 115 merc
Turning Point hustler 14 x 13 prop
22mph gps 3 people
12 F150
Overland Park Ks
Hillsdale Lake, KS
Re: Electrical Question
Do the gauges take (2) 12v inputs? I was looking at a diagram, and it appeared that way- 12V from accessory panel, and 12v from ignition.... or is that just an option of two ways you can hook it up?
Jason
Jason