Page 1 of 1

1996 Tahoe reupolster

Posted: Thu Sep 21, 2017 8:53 am
by CapeDave
2017 new to us 1996 20' Tahoe powered by a 60hp Bigfoot Mercury.
Took about what seemed like all day to pressure wash the mud out of the carpet.
While washing, it was very apparent that it was in desperate need off fence risers.
Ordered up the riser's and a couple of yards of vinyl to see how hard and if I was able to
reupholster the seats.
I will say that this is one fine constructed vessel all aluminum and stainless construction with the exception of the console,
the plywood decking and the plywood in the seat bottoms and under the carpet on the seat bases.
The frames for the seats is aul. square tubing.
The Mercury is amazingly quiet for a two stroke. Ran a little ruff a first but that has cleared up. Had not run in about 5 years.
I only hooked up the engine wiring because I am going to rewire the rest of it with new leds, stereo etcc.....
After I made up and installed the first seat cover I knew it was all going to be done.
So far reupholster in materials is under 400$ I had a Tuff Sew walking foot sewing machine that I use for
repairs on the Hobie cat sails and trampoline.
Well the seats as far as I am conserned are coming out awesome with out spending a fortune on.

Re: 1996 Tahoe reupolster

Posted: Thu Sep 21, 2017 8:57 am
by CapeDave
Sorry bout the big pic. That is Indy and the bottom of the flip seat,

Re: 1996 Tahoe reupolster

Posted: Thu Sep 21, 2017 9:13 am
by curtiscapk
wow that looks amazing!

Re: 1996 Tahoe reupolster

Posted: Fri Sep 22, 2017 1:23 am
by ROLAND
Beautiful pooch, and the seat looks really good.

Re: 1996 Tahoe reupolster

Posted: Mon Sep 25, 2017 1:28 pm
by Wreck Tangle
Good job on the reupolstery