1992 Voyager rebuild

Post your restoration and rebuild projects here.

Moderators: Redneck_Randy, badmoonrising, lakerunner

Message
Author
User avatar
curtiscapk
Posts: 5393
Joined: Mon Nov 10, 2008 8:31 am
Location: OP KS\Hillsdale Lake

Re: 1992 Voyager rebuild

#16 Post by curtiscapk » Thu Jul 22, 2021 6:07 am

+3 on spacers! Using a blower it gets rid of twigs leaves etc. going under the fence!
Craig and Paula
"THE FLOATER" rebuild Spring 2013
viewtopic.php?f=2&t=15328
94 Party Barge 24' 115 merc
Turning Point hustler 14 x 13 prop
22mph gps 3 people
12 F150
Overland Park Ks
Hillsdale Lake, KS

PaulinOK
Posts: 31
Joined: Wed Jan 29, 2020 10:49 am

Re: 1992 Voyager rebuild

#17 Post by PaulinOK » Sat Jul 24, 2021 7:07 pm

curtiscapk wrote:
Thu Jul 22, 2021 6:07 am
+3 on spacers! Using a blower it gets rid of twigs leaves etc. going under the fence!
Well I do appreciate the input! My feeling is the rails (when bolted down and touching the floor) add to the structural integrity so to speak, especially when it comes to how much the entire boat flexes. My floor supports are pretty flimsy, I tore up most of the plywood today and I'm actually going to buy at least a few different supports, MOSTLY because I got a bit of a nasty surprise and found a couple that are damaged, but since I have to buy a few I'm also going to replace the supports at all the plywood joints. I did buy the spacers! I do not know if I'll use them lol.

PaulinOK
Posts: 31
Joined: Wed Jan 29, 2020 10:49 am

Re: 1992 Voyager rebuild

#18 Post by PaulinOK » Sun Aug 01, 2021 3:45 pm

Well I've made very little progress lately, I have started on my console, figured out all the wiring on the switch panel, installed the fuse block, radio and the gps speedometer. Turns out my old steering assembly is to big for the current hole so I'll have to open it a bit, also I'm installing the speakers on both sides of the console so I'll have to cut those holes at the same time. My plan is before I mount the console on the boat I'll also install the remote control and the fish finder. Working on it while it sits on my dining room table is easier than out in the heat :biggrin2
Attachments
PXL_20210801_220251998.jpg
PXL_20210801_220251998.jpg (1.36 MiB) Viewed 14453 times

User avatar
bansil
Posts: 1103
Joined: Tue Nov 01, 2016 4:10 pm
Location: Watâ'gi lake...Beautiful Waters

Re: 1992 Voyager rebuild

#19 Post by bansil » Thu Aug 05, 2021 2:45 pm

:biggrin2
Check out "Dudes" site www.whereisdude.com

Post Reply