Pontoon fence replacement issues
Posted: Fri Jul 12, 2019 9:28 am
So I’ve watched all the videos of how to replace fence metal and it seems pretty easy.... but of course, my boat isn’t like all the ones in the videos!
There is no way for mine to slide in from one of the ends. Both ends have radius corners and the metal fence is captive all the way around it. There is no area to slide into.
I thought about bending the tab back enough to get it in but I’m sure it will break around the corners. If I try to cut the edge off it will look terrible.
So far my only thought is to grind the lower lip off, slide new fence up and then rivet a new lower edge/lip around the bottom.
Other option would be to cut out the lower fence rail, install the new metal then have the lower rail welded in place.
I’m no welder and don’t know much about aluminum welding so not sure how workable that option is?
Ideally I’d like to replace all the fence metal but because of the set up of these fences that might be too much. That leaves me with replacing this missing section and maybe painting everything.
Thoughts?
There is no way for mine to slide in from one of the ends. Both ends have radius corners and the metal fence is captive all the way around it. There is no area to slide into.
I thought about bending the tab back enough to get it in but I’m sure it will break around the corners. If I try to cut the edge off it will look terrible.
So far my only thought is to grind the lower lip off, slide new fence up and then rivet a new lower edge/lip around the bottom.
Other option would be to cut out the lower fence rail, install the new metal then have the lower rail welded in place.
I’m no welder and don’t know much about aluminum welding so not sure how workable that option is?
Ideally I’d like to replace all the fence metal but because of the set up of these fences that might be too much. That leaves me with replacing this missing section and maybe painting everything.
Thoughts?