Pontoon Boat & Deck Boat Forum

Made by Jim Goodman‎ in the facebook group, said he used Marine grade plywood, wrapped the plywood in thin under layer for cushion then covered in carbon fiber material ( comes in various colors. Fastened with #10 metal screws and grommets, to keep the screws flat.
Before I covered, cut out the holes for cup holder and speaker in the front, back cut for rod holder and added led cup holders.



I need to make a set

I made some shelves for mine.

Looks good!

similar to mine, mine are on either side of the front gate. This setup works well and had nice sound imaging on toons with front swivel seats.

I figure you could even hear them while running no problem, that might get me off my ass to get the radio in