Page 1 of 1

cooling problem force 75hp

Posted: Sun Oct 26, 2014 1:28 pm
by sick_46
I have a 98 Tracker Force 75 on my toon. the last time it was out I heard the dreaded temp warning beeper. I shut it down right away so I don't think anything was hurt in the motor. I let the kids swim for a couple of hours before I fired it back up. I was only a few 100 ft from the ramp so I fired it up and headed for the dock. I looked when I fired it up and water was just dribbling out of the pee hole on the motor so I figured it was just a water pump impeller failure. well I finally got it apart today and the impeller looks good and there was no mud in it or anything. Can you guys tell me what I should look for next? thanks

Re: cooling problem force 75hp

Posted: Sun Oct 26, 2014 2:04 pm
by RcgTexas
the impeller looks good
Are the paddles bent or straight? if bent it may mean they aren't working well. if not there may be some blockage somewhere. or possibly a bad thermostat. Hope this is some help.

Re: cooling problem force 75hp

Posted: Sun Oct 26, 2014 4:45 pm
by lakerunner
An impeller that looks good can be bad. Change it anyway

Re: cooling problem force 75hp

Posted: Sun Oct 26, 2014 7:18 pm
by MH Hawker
Depending on how old it is impellers will take a set on the blades and not pump very well. And its sure a place to start.