Pontoon Boat & Deck Boat Forum

Anyone have any recommendations for an aftermarket one of these?

We have a 1995 20' Playbuoy.... just swapped over a used 75hp mariner with a new prop on it and it gets up and goes! (it previously has a 40hp force)

We have one of the ropes that triangulates out from the back of the toons to pull a tuber, but would rather have one of the bars that goes on the transoms.

Anyone have any recommendations?

Thanks!

Melanie

http://turboswingus.com

http://www.amazon.com/Monster-Swing-TSG ... B00ESYPGIK

You could find a welder and have one made.

yep... just have it made.... then have it powder coated....

make a mock-up with PVC...



make sure it fits....



have your welder make it... then, trial fit again...



then, off to the powder coating, then install....