Pontoon Boat & Deck Boat Forum

Posted: **Wed Aug 26, 2015 8:35 pm**

I am adding an under deck ladder to my toon. The 1st screw holes for the ladder frame will be attached to the cross member (any issues using the cross member for this?)

Also the ladder frame is only 1' deep so I will need to add a 1'X2"X2" spacer for the rear of the frame and bolt through the deck. Any suggestions on what I should make the spacer out of? my 1st though is to use wood and epoxy coat it.

Posted: **Thu Aug 27, 2015 4:04 am**

hockey pucks? I'm actually kinda serious, I've used them for various weather proof spacers before.

Posted: **Thu Aug 27, 2015 4:15 am**

Yup. Jeep guys use hockey pucks for a 1" body lift on CJ's and Wranglers.

Posted: **Thu Aug 27, 2015 4:24 am**

Perfect. Thanks guys!

Posted: **Thu Aug 27, 2015 6:41 pm**

The theory at work is everything always comes back to hockey...proved again...go Hawks!

Posted: **Sun Aug 30, 2015 10:47 am**

got the ladder installed. the pucks worked brilliantly.

Pontoon Boat & Deck Boat Forum

Need advice. Installing under deck ladder. Need a spacer

Need advice. Installing under deck ladder. Need a spacer

Re: Need advice. Installing under deck ladder. Need a spacer

Re: Need advice. Installing under deck ladder. Need a spacer

Re: Need advice. Installing under deck ladder. Need a spacer

Re: Need advice. Installing under deck ladder. Need a spacer

Re: Need advice. Installing under deck ladder. Need a spacer