Page 1 of 1
Triton pontoon separating
Posted: Sun Jun 19, 2016 5:59 am
by Stimln
[img][img][/img][/img]
Has anyone seen the center pontoon on a HARRIS floteboat separate about an inch---- 3 to 4 ' in from the motor ? Suggestions noticed it while swimming while Under boat lift
Re: Triton pontoon separating
Posted: Sun Jun 19, 2016 7:47 am
by Bamaman
Never seen it. But have noticed more online leaking complaints on Harris toons than all the other brands combined.
They're too large a pontoon manufacturer to have such problems.
Re: Triton pontoon separating
Posted: Sun Jun 19, 2016 8:37 am
by zoom650
I wish I could check mine and compare it to yours, but I left my Harris at the marina. We're going back on a week or so. What model and length is yours?
Re: Triton pontoon separating
Posted: Sun Jun 19, 2016 9:16 am
by Stimln
Sorry for typos: should say tritoon-
Boat is a HARRIS 240 sun liner 2007
Re: Triton pontoon separating
Posted: Sun Jun 19, 2016 3:07 pm
by slingshot
have you contacted Harris? That's a pretty serious issue!
Re: Triton pontoon separating
Posted: Mon Jun 20, 2016 6:48 am
by willy13
Is that the center toon I am looking at? How does it seperate in the middle, shouldn't it be welded. This is indeed a serious issue!!! I just don't see how that can even happen. Do you have an pics from farther away showing the damage?
Re: Triton pontoon separating
Posted: Mon Jun 20, 2016 8:05 pm
by PlaynDoc
from that 'close up' picture, it looks like the seam was never welded. ????
Re: Triton pontoon separating
Posted: Wed Jun 22, 2016 9:54 pm
by nugilo92
I can't tell for sure, but that looks like just the riser that mounts the deck to the toon, not the toon itself. If that is the case, then i wouldn't worry about it. That is not a watertight area of the boat construction anyways.