Page 1 of 1
Floor replacement question
Posted: Sat Apr 20, 2019 5:58 am
by psrujak
When I took the floor off the 97 pontoon the front section I found a 4x4 bolted to the front of it with a large eye bolt. This was used to connect the winch to. What is the right way to do this or do I use the same setup? I am waiting for marine grade plywood to arrive. Any help or suggestion would be appreciated.
Re: Floor replacement question
Posted: Sat Apr 20, 2019 6:18 am
by lakerunner
I would use a 1/4" aluminum angle across the width of the toon, bolt it to cross member
Re: Floor replacement question
Posted: Sat Apr 20, 2019 7:15 am
by psrujak
Would 2x2x.025x8 work?
Re: Floor replacement question
Posted: Sat Apr 20, 2019 11:32 am
by lakerunner
Don't know why not
Re: Floor replacement question
Posted: Sat Apr 20, 2019 2:15 pm
by psrujak
lakerunner Thanks for your help. I will order the metal.
Re: Floor replacement question
Posted: Mon Apr 22, 2019 6:40 am
by guy48065
psrujak wrote: ↑Sat Apr 20, 2019 2:15 pm
Would 2x2x.025x8 work?
psrujak wrote: ↑Sat Apr 20, 2019 2:15 pm
lakerunner Thanks for your help. I will order the metal.
.25" I hope. .025 would be...aluminum siding trim? Don't order that...
