How much Sharkhide

[garygve]

How much Sharkhide do you need to do a 22' tritoon, I have a new pontoon coming next week and would like to coat it before I put it in the water.

[Bryden24shp]

One qt will more than do it!. I've done 3 Tritoons, 2 my own and one friends and still have 1/3 of a qt left. It does not take much. And I applied 2 coats on each boat. Clean the pontoons off with laquer thinner first, to remove any oil or wax residues which may be on the pontoons.

[STEVEBRENDA]

I was thinking we used more than that, but I am not sure. Contact the people at Sharkhide and they should be able to help.

[garygve]

I hope Bryden is right I ordered 1 Quart yesterday.

[Traillblazer]

I have used it on my pontoons 2 years in a row with 2-3 coats each time on 27' toons and I still have 1/4-1/3 of a can. Same with the polish.

[Bryden24shp]

You'll be fine. Put it on as per directions. It dries super fast. You'll see spots that are missed right away. Just go over those spots with a second coat after the first cures for about 24 hours. It doesn't take alot, just dampen a folded, lint free rag. Apply it so it goes on smooth, if it leaves a "paint brush" texture on the toon, you are using too much. Its easy to use.
I just checked my can, I I still have a good 1/4 of the quart remaining, after 3 boats. When storing it, I put a plastic bag under the cap. So it stays fresh in the can. I bought these 2 quarts from Clint back in 2007 when I bought my Manitou. My 2nd quart remains unopened, but I'm going to re-do my polish job in a few weeks, so I'll crack it open, then.
Just as Trailblazer re-inforced, you'll be good!