Tracker party hut power question

Message

wijames · #1 Post by **wijames** » Mon Sep 29, 2014 1:25 pm

Does anyone know if the lights on a 1993 party hut would be 12 volt or 110? Also did tracker run the wires alond the edges of the top rail? I cant figure out the wiring at all on this thing.

RcgTexas · #2 Post by **RcgTexas** » Mon Sep 29, 2014 2:23 pm

Just a wag but probably 12 volt. even if it has a generator, navigation lights are usually 12 volt on that size boat.

Some one feel free to correct me.

#3 Post by **badmoonrising** » Mon Sep 29, 2014 4:20 pm

I had a 2006 Party Cruiser and everything was 12 volts except for the stove, A/C, and microwave..lights are all 12 volts. even the fluorescent cabin interior lights.

wijames · #4 Post by **wijames** » Tue Sep 30, 2014 6:10 am

badmoonrising wrote:I had a 2006 Party Cruiser and everything was 12 volts except for the stove, A/C, and microwave..lights are all 12 volts. even the fluorescent cabin interior lights.

Thanks, thats what I figured. Were the cabin ceiling lights on an accesory switch or wired directly into the system? None of my interior lights work so I'm trying to trace where the power for them starts.

#5 Post by **badmoonrising** » Tue Sep 30, 2014 7:04 am

They were wired directly to the fuse panel 12v, under the console. The circuit is always on, no switch.

wijames · #6 Post by **wijames** » Wed Oct 01, 2014 8:15 am

badmoonrising wrote:They were wired directly to the fuse panel 12v, under the console. The circuit is always on, no switch.

Thanks. That makes it a little harder to trace.

Pontoon Boat & Deck Boat Forum

Tracker party hut power question

Tracker party hut power question

Re: Tracker party hut power question

Re: Tracker party hut power question

Re: Tracker party hut power question

Re: Tracker party hut power question

Re: Tracker party hut power question