Suntracker 22DLX Fishn Barge measurement???

[Tlowry]

Howdy,

I'm going to put a washdown and small sink on the boat. Problem is the boat is at the lake 100 miles away and I need to know the dimension of the area I want to mount the sink in. I want to remove the, for a lack of a better term, 'pillow' from the changing room top. I need the width of the changing room base as well as the distance from the outboard railing to the hinge.

I would greatly appreciate anyone that has this boat close at hand to run a tape measure for me.

Thanks,
Tom

[JBO]

Did you try calling the mfger?

[Tlowry]

Kinda of hoping one of the many that has these boats and are near them could take a couple quick measurements rather than wading through the departments at Tracker to get the answer.

[JBO]

Kinda of hoping one of the many that has these boats and are near them could take a couple quick measurements rather than wading through the departments at Tracker to get the answer.

They likely have a floorplan they can send you with exact measurements and blueprints. Probably takes less time than a couple forum posts, IMO. There are lots of boats out there, but not all are going to be the same year and model as yours.

[mzodarg]

I just saw this and have the same pontoon, I'm heading to lake this morning and will measure what you requested. It will be later today before I'll get back with you.

Mike

[mzodarg]

Just measured the area you requested is 11"X25"

[Tlowry]

Thank you mzodarg, now I can see what kind of sink I can get to fit that space.

[mzodarg]

Thank you mzodarg, now I can see what kind of sink I can get to fit that space.

No problem. Hey I see in another thread that you changed your prop. what did you end up going with?

[Tlowry]

Thank you mzodarg, now I can see what kind of sink I can get to fit that space.

No problem. Hey I see in another thread that you changed your prop. what did you end up going with?

Looked the box it cam in which now contains the Spitfire that came on the motor and it says 14x13 and it's a three blade. It still needs a little tweek as I still only get 5600 tops so I will fiddle with with the prop slippage calculator and take it to a local prop shop.