I GIVE UP! Condensation under mooring cover...

You know the drill..

Moderators: Redneck_Randy, badmoonrising, lakerunner

Message
Author
Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

I GIVE UP! Condensation under mooring cover...

#1 Post by Tooner606 » Fri Jul 15, 2016 6:34 am

Ok folks, this issue has me totally perplexed.
1-FullSizeRender.jpg
1-FullSizeRender.jpg (121.34 KiB) Viewed 6216 times
I have a 22' Sweetwater that is about to drive me crazy. Almost every time I uncover the boat, I find a large wet spot (puddle) on the carpet next to the captains seat.

At first I thought the cover was leaking but I've gone as far as to go sit under the cover during a downpour and the cover does not leaking...at least not that I can tell. What I have noticed is that on hot days (80's), the underside of the cover gets soaking wet with condensation, to the point were there are droplets of water all over the inside of the cover. I suspect this condensation is what is creating the puddle(s) on the carpet.

As you can see in the picture, the cover has 6 vents (Boat Vent II), one on the end of each pole. Shouldn't this be enough to keep this boat ventilated?

I try never to cover the boat wet as I don't want to create a mildew issue, but this is driving me crazy! Has anyone else experienced this problem. Any solutions?

Thanks,

KPC

Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

Re: I GIVE UP! Condensation under mooring cover...

#2 Post by Tooner606 » Fri Jul 15, 2016 6:48 am

boat vent II.jpg
boat vent II.jpg (29.35 KiB) Viewed 6220 times

FWIW, these are the vents that each of the six poles slip into.

KPC

User avatar
lakerunner
Site Moderator
Posts: 4820
Joined: Fri Mar 17, 2006 2:31 pm
Location: Live in McAlester, Ok Boat on Tenkiller
Contact:

Re: I GIVE UP! Condensation under mooring cover...

#3 Post by lakerunner » Fri Jul 15, 2016 7:00 am

Do you have power at your dock? If so get a box fan and keep it running
Loyd & Betty Meeks
Livin the lake life
2004 Tracker 22 Regency/2010 90 E-Tec. Pulled by Ford 2020 F 250,
McAlester, Oklahoma
Home lake is Tenkiller

Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

Re: I GIVE UP! Condensation under mooring cover...

#4 Post by Tooner606 » Fri Jul 15, 2016 7:15 am

Thanks, but no power at the dock.

I've even thought about leaving the side door open for additional air exchange, but I don't really want to have critters getting into the boat and leaving their mess. (happened to a friend)

:donno

KPC

User avatar
PlaynDoc
Posts: 1600
Joined: Wed Mar 09, 2011 7:32 am
Location: Milner, Georgia

Re: I GIVE UP! Condensation under mooring cover...

#5 Post by PlaynDoc » Fri Jul 15, 2016 8:15 am

since no power at dock, get solar powered fan... sounds like you're trapping air/moisture... it's gotta circulate....

and/or, find a way to open 'water' side of boat cover <so critters can't get in>
2011 SunChaser DS22
Mercury 115 EFI
13.75 x 15p

Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

Re: I GIVE UP! Condensation under mooring cover...

#6 Post by Tooner606 » Fri Jul 15, 2016 8:54 am

PlaynDoc wrote:...and/or, find a way to open 'water' side of boat cover...
I might try to leave the water side door open for additional air exchange.
Untitled.jpg
Untitled.jpg (34.33 KiB) Viewed 6157 times
I've avoided doing that because a friend had a problem with a Cormorant getting into his boat and puking up, tearing apart, and crapping out his daily kills.

:x

KPC

User avatar
rob28
Posts: 160
Joined: Sun Feb 24, 2013 8:35 am
Location: Dryden, Ontario. In the wilderness.

Re: I GIVE UP! Condensation under mooring cover...

#7 Post by rob28 » Fri Jul 15, 2016 9:13 am

We always leave the front and rear doors open when the cover is on to allow air flow through the whole boat. We don't really have the condensation issue but when it rains the carpet will get drenched whether doors are open or closed - this just allows the carpets to dry out faster.
Never had an issue yet with critters.
Used to be a 2013 Sylvan Mirage Cruise 8520 LE powered by a Merc 50 Bigfoot.
Now we have a 2019 Sylvan Mirage 8522 DLZ LE powered by a Yamaha VF150..
2010 F-150 4.6L to haul it around.
You'll find us enjoying life on the Wabigoon.

BobL
Posts: 589
Joined: Fri Jun 25, 2010 10:41 am
Location: Louisiana

Re: I GIVE UP! Condensation under mooring cover...

#8 Post by BobL » Fri Jul 15, 2016 9:41 am

Tooner606 wrote:Almost every time I uncover the boat, I find a large wet spot (puddle) on the carpet next to the captains seat.
The above quote has me scratching my bald head.

I live in Louisiana (think rain, heat, humidity) and general condensation is not going to leave a "puddle", especially in one specific location. My first boat had carpet and the entire inside was moist/damp because the carpet never really dried out after a rain and the cover did not breath worth a crap. I installed the vents like you have but nothing helped. The cover was a cheap OEM from Bentley and it did not breath worth a crap.

Anyway, back to the puddle by the captains seat.....My boat usually gets rained on 2/3 times a month when it is tied to the dock and not on my covered lift. What I have found is that water pools under the console/helm and since the boat leans to the stern, I will notice a puddle around my captains chair. Maybe that is what is happening???
SOLD - 2009 20' Bentley w/4 Stroke 90hp Mercury
SOLD - 2011 SouthBay 522CR w/115 4 Stroke Mercury
2014 Xcursion 23RF XS package w/150 4 Stroke Mercury

Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

Re: I GIVE UP! Condensation under mooring cover...

#9 Post by Tooner606 » Fri Jul 15, 2016 10:45 am

I get what you're saying Bob, it's confusing to me too. I'm thinking the condensation is running down the inside of the cover and dripping in a certain area.

My boat is covered all the time that it is not in use so the idea that rain water is pooling under the helm and then leaking out is unlikely.

I will try to take a picture under the cover next time it happens.

Like I said, it's driving me crazy!!

:donno

KPC

User avatar
curtiscapk
Posts: 5445
Joined: Mon Nov 10, 2008 8:31 am
Location: OP KS\Hillsdale Lake

Re: I GIVE UP! Condensation under mooring cover...

#10 Post by curtiscapk » Fri Jul 15, 2016 11:15 am

Try a bucket of charcoal... I winterize with one.
Attachments
DSCN0568a.JPG
DSCN0568a.JPG (85.61 KiB) Viewed 6113 times
Craig and Paula
"THE FLOATER" rebuild Spring 2013
viewtopic.php?f=2&t=15328
94 Party Barge 24' 115 merc
Turning Point hustler 14 x 13 prop
22mph gps 3 people
12 F150
Overland Park Ks
Hillsdale Lake, KS

User avatar
PlaynDoc
Posts: 1600
Joined: Wed Mar 09, 2011 7:32 am
Location: Milner, Georgia

Re: I GIVE UP! Condensation under mooring cover...

#11 Post by PlaynDoc » Fri Jul 15, 2016 11:38 am

eh, what the hell... at the puddle area, drill a hole through the floor! puddle gone. hehe
2011 SunChaser DS22
Mercury 115 EFI
13.75 x 15p

Tooner606
Posts: 12
Joined: Thu May 16, 2013 5:39 am

Re: I GIVE UP! Condensation under mooring cover...

#12 Post by Tooner606 » Fri Jul 15, 2016 1:28 pm

Untitled.jpg
Untitled.jpg (241.96 KiB) Viewed 6078 times

Here is the area that I'm talking about. I took a pic under the mooring cover this afternoon. There wasn't a puddle today, but you can see a mild discoloration of the carpet where the water was.

Vinyl floor in back is never wet, just the carpet in the area noted.

KPC

TDJ2591
Posts: 360
Joined: Mon Jun 02, 2014 4:33 pm
Location: Smith Lake, AL

Re: I GIVE UP! Condensation under mooring cover...

#13 Post by TDJ2591 » Fri Jul 15, 2016 3:29 pm

Maybe there's a correlation between the boudoir look under the cover and the moisture. Love the look!

Could you rig up some type of screens for the doorways to keep out the critters and then leave the doors open for cross ventilation? I would look at a solar powered fan as well.
[color=#4000FF]2005 Crest Caribbean 25'
2006 Honda 135hp 4 stroke[/color]

User avatar
MH Hawker
Posts: 1434
Joined: Sat Aug 20, 2011 4:13 pm
Location: West Virginia

Re: I GIVE UP! Condensation under mooring cover...

#14 Post by MH Hawker » Sat Jul 16, 2016 11:59 pm

what type of material is it made of, sumbrella or a PVC covered cloth
If it aint broke your not having enough fun

James & Deb

1988 Riviera Cruiser 15 HP Mariner
05 Silverado Z 71 V8 5.3

ron nh
Posts: 979
Joined: Sun Sep 21, 2014 1:07 pm
Location: Litchfield New Hampshire

Re: I GIVE UP! Condensation under mooring cover...

#15 Post by ron nh » Sun Jul 17, 2016 4:05 am

MH Hawker wrote:what type of material is it made of, sumbrella or a PVC covered cloth
That's what I was wondering, It'd have to be a 1/2" hefty bag to gain that much water.
2015 Qwest LS 818XRE Tri-toon w/mercury 115.

Post Reply